11/28/2023 0 Comments Tape line measurementsPhoto: The true zero hook feature will keep measurements accurate. This lets you quickly identify joists without using a stud finder, helpful when nailing floorboards. Joist measurement: Black diamonds located every 19 3/16 inches indicate on-center joist spacing.Keep in mind that the second stud in a wall is installed 16 inches from the end of the wall, not from the center of the first stud. So if, for example, you’re installing baseboard trim, you can lay the measuring tape across the wall and use the red squares to locate the studs behind the drywall. Stud measurements: Red squares every 16 inches indicate on-center wall stud spacing.Understand these important additional measurements. It is not indicated by a number or fraction, but simply by the smallest line on the metric side of the blade, with every fifth millimeter line being slightly longer to indicate the halfway point between centimeters. Millimeter or 1mm: The smallest metric measurement on the blade is the millimeter.This measurement can be found at every 10th millimeter marking. Centimeter or 1cm: This measurement is indicated by the longest line on the metric side of the blade and a large number.This measurement is located at every 10th centimeter line. Decimeter or 1dm: The one-decimeter marking is normally shown at a red numeral of 10.On some tape measures, the centimeters will begin at one following the meter marking. Meter or 1m: The one-meter marking is located at the one 100th centimeter marking or 10th decimeter marking.Read a tape measure’s incremental marks for the metric system. Sixteenth or 1/16”: The shortest line on the imperial measurements indicates a 16th of an inch and doesn’t normally have a fractional representation.This line may also be indicated by a fractional representation. Eighth or 1/8”: The second shortest line on the imperial measurements is listed as an eighth of an inch.It may also be indicated with a fractional representation, similar to the half inch. Quarter or ¼”: The mid-size line is the third longest and the third shortest on the typical tape measure.Some measuring tapes only show the line as a measurement indicator, while others will show the line and the fractional representation of the measurement. Half or ½”: The second longest line is the half inch measurement. This line is indicated by a large number sitting to the left of the line.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |